Jiffster
Well-Known Member
- Joined
- Aug 8, 2015
- Messages
- 806
- Reaction score
- 109
I'm thinking about trimming off the plastic on the front of the can that is used by the trucks to lift the can and dump it.
This would be so I can raise the height of where the faucets (4) could be located. Otherwise they would be too low in my opinion.
I think a Dremel would do it best. Any advice on which model I should get?
View attachment ImageUploadedByHome Brew1464343203.096479.jpg
View attachment ImageUploadedByHome Brew1464343217.351535.jpg
View attachment ImageUploadedByHome Brew1464343238.060094.jpg
This would be so I can raise the height of where the faucets (4) could be located. Otherwise they would be too low in my opinion.
I think a Dremel would do it best. Any advice on which model I should get?
View attachment ImageUploadedByHome Brew1464343203.096479.jpg
View attachment ImageUploadedByHome Brew1464343217.351535.jpg
View attachment ImageUploadedByHome Brew1464343238.060094.jpg