RIMS wiring diagram version 2

[terodox]

This is my proposed wiring diagram for a rims in a box. My biggest question is what do I need to worry about four lights?

Are they affected by the draw from the other thing in the circuit? My gut says no, but I want to be sure.

Link to diagram:
https://www.circuitlab.com/circuit/ee8jgh/rims-tube-rebuild/

Thanks in advance for any feedback!

 

[mattd2]

That was a bit confusing at first
You need to move the pump switch down to the bottom line, otherwise your PID won't run unless the pump is switched on.

 

[terodox]

Good catch! Updated it. Any answer for my light question?

 

[mattd2]

I guess I'll answer your question with another question Do you have any ideas on what switches/lights you are going to be using. A lot of people on here use the illuminated pushbutton switches from automation direct (i think thats the vendor). The benifits are you only have to drill 1 hole for the switch and light. These can be wired I think so it takes a hot after the switch which goes to the light and the other side of the light goes to nuetral.

 

[terodox]

Sweet! That is a perfect answer to my question! Here's the link to the LED push button lighted switches from Automation Direct:

http://www.automationdirect.com/adc/Shopping/Catalog/Pushbuttons_-z-_Switches_-z-_Indicators/22mm_Plastic/Illuminated_Pushbuttons_Flush_-a-_Extended/LED