I am trying to figure out how I am going to setup my RIMS tube. Right now I am thinking that I am going to run the mashtun into the RIMS tube past the temp probe first. Then out to the pump and from the pump to the mashtun.
Don't you worry about the wort cooling off on the way to the temp probe? I brew outside so during the winter the wort wouldn't be the same temp as the grain bed. I do plan on insulating the tubing and mashtun.
On the valve. I am going to use a gate valve on each pump.
Don't you worry about the wort cooling off on the way to the temp probe? I brew outside so during the winter the wort wouldn't be the same temp as the grain bed. I do plan on insulating the tubing and mashtun.
On the valve. I am going to use a gate valve on each pump.
If you look at Kal's page he monitors the mash temp in the T right after the MT.
I am going to run it as suggested. I have a temp probe in the mash too so I can monitor that