wobdee
Junior Member
Bought the new Co2Po regulator from N Brewer. After a couple days of nothing but problems I called them and they sent a new one. This one is acting the same way. When you turn the dial to adjust the psi it's slow to react. Pour a beer or two and the psi drops down from 12 to 6 and it's not reacting in real time to keep up at 12 psi. If I leave it alone for a few minutes it finally reacts and slowly comes back up but not to where I set it. If I tighten the dial to get it back to 12 and leave it, it will creep up to 15+ over time.
N Brewer says it will loosen up in time and should work fine. Not sure about that, Ive had other regulators that have never done this. Anyone ever see something like this or have any advice? Thanks
N Brewer says it will loosen up in time and should work fine. Not sure about that, Ive had other regulators that have never done this. Anyone ever see something like this or have any advice? Thanks
