Re-soldering a bulkhead into HLT

[In_Vino_Veritas]

So last night I soldered a couple bulkheads into my HLT, soldering from the inside. This morning I see that the bulkhead side that's deeper into the HLT, which has lower visibility did not fully melt. The bulkhead is pressed in, so there is good shelf for the solder to sit in. Can I clean, flux, add another solder ring and re-solder?

Sorry, perhaps this could go in the sticky; I wasn't sure it'd been seen.

 

[wilserbrewer]

Yes, no reason you can't clean, apply flux and solder again without removing the fitting.

 

[In_Vino_Veritas]

Yes, no reason you can't clean, apply flux and solder again without removing the fitting.

Thanks for the help!