Question about gas plumbing on single tier brewstand

[dareibreathe1]

Just got my new burners in yesterday along with my needle valves and ball valves to shut off each burner. I'm about to go to Home Depot to pick up piping and fittings to start putting it all together. I am wondering if it is possible to use my regulator and hose from my bayou classic SQ-14 to hook up the tank to my piping? My only concern is that the hole on the end of the orifice is extremely small, about the size of a framing nail. I'm assuming this is because it was intended to be hooked up to one burner not to a manifold feeding 3 burners. So will this work or should I buy a new regulator and hose setup? Thanks

 

[estricklin]

Can the hose be removed from the regulator? I think on a lot of the cheap sets it cannot be removed.