Drgonzo65
New Member
- Joined
- Jun 28, 2015
- Messages
- 2
- Reaction score
- 0
I've just recently finished a Brutus 10 build using the Honeywell Y8610U for pilot lighting and propane control.
I'm having one big issue... I turn on the propane, and I hear it enter the gas beam. Then I send power to the controller, which starts the call for heat. The pilot starts sparking, but no flame. To test it out, I even tried putting a flame to the pilot burner, and interestingly enough, air blows the lighter flame. After about 10 mins of not lighting, it finally lights with the spark, and can continue to relight every time I turn it off and back on again.
It seems like the air /propane mix is off for a while, until it just starts working. Anyone else seen this? Once everything lights, it works well.
Thanks
I'm having one big issue... I turn on the propane, and I hear it enter the gas beam. Then I send power to the controller, which starts the call for heat. The pilot starts sparking, but no flame. To test it out, I even tried putting a flame to the pilot burner, and interestingly enough, air blows the lighter flame. After about 10 mins of not lighting, it finally lights with the spark, and can continue to relight every time I turn it off and back on again.
It seems like the air /propane mix is off for a while, until it just starts working. Anyone else seen this? Once everything lights, it works well.
Thanks