Smashedcat
Member
- Joined
- Jan 30, 2022
- Messages
- 8
- Reaction score
- 2
Been out of the brewing game a few years, decided to go grab a new C02 and keg and start brewing again.
I’ve previously force carb’d, this was done by attaching gas to the out… I assume like everyone else does.
The new setup I have, I force carb’d as normal. I went to swap inputs and neither are a tight fit. Gas and liquid both leak, so what gives here? If I swap them they’re very tight.
My kegging knowledge is pretty minimal, so I would have guessed the posts were different sizes and someone swapped them, but if I even can make that change, I wouldn’t be able to force carb.
Any advice/knowledge here is greatly appreciated. I searched the forums and found some varying post sizes, so I think I’m just looking for the generalized solution to dispensing and carbonating.
I’ve previously force carb’d, this was done by attaching gas to the out… I assume like everyone else does.
The new setup I have, I force carb’d as normal. I went to swap inputs and neither are a tight fit. Gas and liquid both leak, so what gives here? If I swap them they’re very tight.
My kegging knowledge is pretty minimal, so I would have guessed the posts were different sizes and someone swapped them, but if I even can make that change, I wouldn’t be able to force carb.
Any advice/knowledge here is greatly appreciated. I searched the forums and found some varying post sizes, so I think I’m just looking for the generalized solution to dispensing and carbonating.
Last edited: