Ok I bit the bullet and will build a single tier brewstand with struts after reading this thread, the stand building itself is not and issue and pretty straightforward... my brain go into slowmo when trying to figure out how to "plumb" it
think already have all the parts, (homedepot is not that far, and I've never done a project without going there at least a couple times!) here's my planned setup: 8 gallon kettle as HLT, 10 gallons Igloo cooler as Mash tun, 10 gallon Blichmann kettle for wort, 2 chugger pumps, blichmann Therminator to cool stuff down, 2 burners, blichmann auto sparge for the MLT, also have a water filter to plumb in the deal.... My plan is to hard plumb the stand and add quick disconnect for moveability. I need guidance for the plumbing part... Thanks in advance...