VikeMan
It ain't all burritos and strippers, my friend.
- Joined
- Aug 24, 2010
- Messages
- 5,984
- Reaction score
- 6,249
Just got a TS-13010 controller for my keezer build. The dimensions of the faceplate are not a whole lot bigger than the required 'opening' dimensions, so I guess precision cutting would be good. 
What would be the best way to cut this opening (in '1 x' red oak). I do have a router and a table if there's a good way to do it with that, though I'm having trouble picturing the setup. TIA!
---VikeMan
What would be the best way to cut this opening (in '1 x' red oak). I do have a router and a table if there's a good way to do it with that, though I'm having trouble picturing the setup. TIA!---VikeMan
