Leaky Perlicks?

[rudy0498]

I was just getting my new draft tower cleaned up and ready for a beer I just kegged. I ran some oxyclean and sanitizer through the lines. When I closed the faucets (which are new perlicks) the flow stops for a couple seconds and then a few more drops run out. It seems to happen the same way every time I closed the either faucet.

Is there something I can adjust to make this stop?

 

[MoRoToRiUm]

https://www.homebrewtalk.com/f35/perlick-forward-seals-heavy-tap-handles-100858/ this thread has gone a little off topic, but adjusting the pull helps. I had the same issue, especially when I put on my 12 inch english pub handles. I have it to the point where I get two to three drips after closing, just from adjusting. Good luck!