I recently finished my weldless keggle conversion using Bargain Fittings bulkheads and a side pickup tube.
The keggle holds water fine. When I drain it it drains well until the water level hits about the middle of the bulkhead and then stops. This leaves about 1 to 1.5 gallons of water in the bottom of the keg.
I figured the tube was to long so i cut a couple of inches off of it and now it is inbetween a side pickup and a center pickup tube. This didn't seem to improve my siphoning problem.
Can anyone give me any insight?
The keggle holds water fine. When I drain it it drains well until the water level hits about the middle of the bulkhead and then stops. This leaves about 1 to 1.5 gallons of water in the bottom of the keg.
I figured the tube was to long so i cut a couple of inches off of it and now it is inbetween a side pickup and a center pickup tube. This didn't seem to improve my siphoning problem.
Can anyone give me any insight?