Milled grain on Friday. No, I should write attempted to mill grain on Friday. I'm very frustrated with the Keg King Malt Muncher 3. No matter how I set the roller gap (my system uses a loose 0.045 gap) the mill either stops turning or only turns 1 roller (in effect I now have a 1 roller mill. I know there is only 1 driven roller. I'm writing about the 2nd top roller binding and then not turning.)
After using in March (and I had also had problem in March too. Actually, I've had problems every time I've used the Keg King MM3) I disassembled and thoroughly cleaned everything. Normally, I clean the rollers/hopper, etc without completely disassembling everything.
Anyone recommend anything I can do to get the Keg King MM3 to reliably work before I put the frustrating thing out by the curb for trash pickup?
I appreciate any helpful input.
Thanks.
After using in March (and I had also had problem in March too. Actually, I've had problems every time I've used the Keg King MM3) I disassembled and thoroughly cleaned everything. Normally, I clean the rollers/hopper, etc without completely disassembling everything.
Anyone recommend anything I can do to get the Keg King MM3 to reliably work before I put the frustrating thing out by the curb for trash pickup?
I appreciate any helpful input.
Thanks.