BeantownR6
Well-Known Member
4 lb Light DME
3.5 lb Pale Malt, Maris Otter (3.0 SRM)
1.75 lb Munich Malt (9.0 SRM)
1.00 lb Honey Malt (25.0 SRM)
0.50 lb Caramel/Crystal Malt - 60L (60.0 SRM)
0.50 lb Caramel/Crystal Malt - 80L (80.0 SRM)
0.75 oz Nugget [13.00%] (60 min) (First Wort Hop)
0.50 oz Amarillo Gold [8.90%] (45 min)
0.50 oz Centennial [10.00%] (30 min)
0.50 oz Amarillo Gold [8.90%] (15 min)
0.50 oz Cascade [7.80%] (10 min)
0.50 oz Cascade [6.10%] (5 min)
0.50 oz Centennial [10.00%] (0 min)
.50 oz Amarillo Gold [8.90%] (Dry Hop 7 days)
.50 oz Centennial [10.00%] (Dry Hop 7 days)
.50 oz Glacier [5.60%] (Dry Hop 7 days)
this recipe was based on BM's outer limits IPA, mash at 159
5 Gallon batch
estimated OG=1.074 (Qbrew)
I think the place i ordered my grains from messed up on the munich malt, i ordered 1lb 12oz but on the bag it said 1.12 lbs. it was already premixed with all the other grains so i couldn't tell.
on to brewing. the formulas below i used from john palmers online book.
7.25lbs grains x 1.5 qt/lb = 2.72 gal for mash.
tw=(.2/1.5)(159-75)+159=170 for strike water in kettle.
i mashed in my kettle in a grain bag. now i use a digital temp cooking gauge and heated water to just over 170, brought inside to cool to 170. i just bought a turkey fryer to boil in and i checked the digital temp against the thermometer the turkey fryer came with, i never trusted the digital one. they both gave me a reading of 170, its harder to read the thermometer. when i added the grains and mixed, the digital thermometer never dropped below 161 the whole 60 minute mash, but the other thermometer read just a tad over 150 at the end of the 60 minutes, maybee 152, 153 hard to tell. i wasn't sure what it read when i started the mash. i wrapped the kettle in a towel and one over the top. stirred about 4-5 times in 60 minutes.
i then heated up 3.5 gallons of water to 170 and steeped grains for 10 minutes, then poured into turkey fryer. i measured just under 5 gallons and added water to 6 gallons, added 4 lbs DME and took a reading.
SG (gravity before boil) 1.060 cooled to 80 degrees. adjusted 1.062
at about 25 minutes i had boiled off almost a gallon, so i added a 1/2 gallon of water to the boil.
end of boil i brought the kettle inside and used my immersion wort chiller and got it down to somewhere around 80-85 degrees.
then i noticed it, there is a ****ing termite in my cooled wort. i have no idea if it got there in the boil, or after. is this going to kill my beer?
OG of the wort is 1.071 @ 85 degrees. adjusted 1.074. wort collected was a tad under my 5 gallon line. i estimate 4.85-4.9 gallons. i poured in most of the crap from the kettle, just a small hop residue was left.
so how did i do? can someone tell me what my efficency is? i used 75% in my formula.
my 2 concers are
1. termite in wort.
2. unsure about mash temp cause of crappy thermometer. can anyone suggest a good one to get?
3.5 lb Pale Malt, Maris Otter (3.0 SRM)
1.75 lb Munich Malt (9.0 SRM)
1.00 lb Honey Malt (25.0 SRM)
0.50 lb Caramel/Crystal Malt - 60L (60.0 SRM)
0.50 lb Caramel/Crystal Malt - 80L (80.0 SRM)
0.75 oz Nugget [13.00%] (60 min) (First Wort Hop)
0.50 oz Amarillo Gold [8.90%] (45 min)
0.50 oz Centennial [10.00%] (30 min)
0.50 oz Amarillo Gold [8.90%] (15 min)
0.50 oz Cascade [7.80%] (10 min)
0.50 oz Cascade [6.10%] (5 min)
0.50 oz Centennial [10.00%] (0 min)
.50 oz Amarillo Gold [8.90%] (Dry Hop 7 days)
.50 oz Centennial [10.00%] (Dry Hop 7 days)
.50 oz Glacier [5.60%] (Dry Hop 7 days)
this recipe was based on BM's outer limits IPA, mash at 159
5 Gallon batch
estimated OG=1.074 (Qbrew)
I think the place i ordered my grains from messed up on the munich malt, i ordered 1lb 12oz but on the bag it said 1.12 lbs. it was already premixed with all the other grains so i couldn't tell.
on to brewing. the formulas below i used from john palmers online book.
7.25lbs grains x 1.5 qt/lb = 2.72 gal for mash.
tw=(.2/1.5)(159-75)+159=170 for strike water in kettle.
i mashed in my kettle in a grain bag. now i use a digital temp cooking gauge and heated water to just over 170, brought inside to cool to 170. i just bought a turkey fryer to boil in and i checked the digital temp against the thermometer the turkey fryer came with, i never trusted the digital one. they both gave me a reading of 170, its harder to read the thermometer. when i added the grains and mixed, the digital thermometer never dropped below 161 the whole 60 minute mash, but the other thermometer read just a tad over 150 at the end of the 60 minutes, maybee 152, 153 hard to tell. i wasn't sure what it read when i started the mash. i wrapped the kettle in a towel and one over the top. stirred about 4-5 times in 60 minutes.
i then heated up 3.5 gallons of water to 170 and steeped grains for 10 minutes, then poured into turkey fryer. i measured just under 5 gallons and added water to 6 gallons, added 4 lbs DME and took a reading.
SG (gravity before boil) 1.060 cooled to 80 degrees. adjusted 1.062
at about 25 minutes i had boiled off almost a gallon, so i added a 1/2 gallon of water to the boil.
end of boil i brought the kettle inside and used my immersion wort chiller and got it down to somewhere around 80-85 degrees.
then i noticed it, there is a ****ing termite in my cooled wort. i have no idea if it got there in the boil, or after. is this going to kill my beer?
OG of the wort is 1.071 @ 85 degrees. adjusted 1.074. wort collected was a tad under my 5 gallon line. i estimate 4.85-4.9 gallons. i poured in most of the crap from the kettle, just a small hop residue was left.
so how did i do? can someone tell me what my efficency is? i used 75% in my formula.
my 2 concers are
1. termite in wort.
2. unsure about mash temp cause of crappy thermometer. can anyone suggest a good one to get?