It's getting there

[Welderbydaybrewerbynight]

Got about 2/3rds the piping done and controls on there way, have to pipe in the filter and heat exchanger tomorrow.

 

[Welderbydaybrewerbynight]

All the sanitary piping is now fit up and about 90 percent of it is welded

 

[Welderbydaybrewerbynight]

65 sanitary welds later all the welding and fitting is complete finally

 

[Welderbydaybrewerbynight]

Got all the electronic and ss conduit ran this weekend, and the control box mounted with all the new components mounted in our.

 

[Facebrewing]

Wow. Very awesome skills brother. Love the way you built that sparge arm and all that sanitary piping is killer. Total stainless porn.

 

[Welderbydaybrewerbynight]

Thank you

 

[dadshomebrew]

I think my beer gut just got a boner

 

[Welderbydaybrewerbynight]

Grrrrrrrrrrrrr these RTD pt100 tri clamp sensors are giving me major problems

 

[Markd27]

This is fantastic. Great build.

 

[Welderbydaybrewerbynight]

Got three of the four pids communicating with the new rtds. The old one will just not take to the rtd tried everything grrrrr

 

[Hello]

That is beautiful. Nice work.

 

[Welderbydaybrewerbynight]

New natural gas line to the garage, and a branch line for a pool heater got ran this weekend, good to get that done. Just waiting on a 32' ss braided flex line with quick disconnects. Still can't get the old 4352 pid to read the new rtd, the new ones with great though. That one of course runs the ruins tube though.

 

[Carlscan26]

I am so jealous of your skills!

Is it kosher to have electrical in the flex tube inside of a SS pipe like that? Does that tube get in the way of accessing the kettles?


Sent from my iPhone using Home Brew

 

[Welderbydaybrewerbynight]

I am so jealous of your skills!

Is it kosher to have electrical in the flex tube inside of a SS pipe like that? Does that tube get in the way of accessing the kettles?


Sent from my iPhone using Home Brew

I just got to remove the kettles from the back of the rig the tops of them are all below the conduit so no issues with acess there. I wanted to protect the expensive rtd sensor cables and have a clean look so I ran all the wiring for them and the rims tube in there I don't know why it would be an issue running flex in the conduit normally theres just bare wire ran in them so you would think having flex around the electric cables would just be added protection. Thank you