Good day everyone. I have finished building an electric brewery (Kal clone) but bought these ink bird TA series long before the decision. I'm hoping someone has come across this issue I'm having, been looking on here and other sites for a couple days now, so it's time to pose the question.
They come with the default being a K type sensor so I changed them to RTD in the setup and the first one was off by about 5' so adjusted it with the offset and is good. The second one I changed to RTD and the temp readout is at - 420' I can change it back to K and it's alot closer to the actual air temp, the offset is not great enough to adjust it from - 420. So has anyone run across this before and any help would be greatly appreciated.
Thanks, Fred.
They come with the default being a K type sensor so I changed them to RTD in the setup and the first one was off by about 5' so adjusted it with the offset and is good. The second one I changed to RTD and the temp readout is at - 420' I can change it back to K and it's alot closer to the actual air temp, the offset is not great enough to adjust it from - 420. So has anyone run across this before and any help would be greatly appreciated.
Thanks, Fred.
