I have three 2352 PIDs and the cycle time is way high on all three.
I set t=2, which should make the cycle time be 2 seconds, but the actual cycle time vary between the three PIDs and they are all way high.
HLT: 3.0 sec, RIMS: 4.4 sec, BK: 7.3 sec.
Why?
A good way to measure the cycle time is to set the PID to manual and 3% output. It is then easy to time the LED blips with a stop watch.
Anyone else notice this problem?
Has anyone successfully disassembled one of these PIDs?
I set t=2, which should make the cycle time be 2 seconds, but the actual cycle time vary between the three PIDs and they are all way high.
HLT: 3.0 sec, RIMS: 4.4 sec, BK: 7.3 sec.
Why?
A good way to measure the cycle time is to set the PID to manual and 3% output. It is then easy to time the LED blips with a stop watch.
Anyone else notice this problem?
Has anyone successfully disassembled one of these PIDs?