johnlvs2run
Well-Known Member
I have wired a love temperature controller TS-13010 version 2, May 2008.
The programming instructions are not very clear.
All that I get when I press [set] is a number that goes from -50 to 150 degrees.
When I press [set] again it just goes back and forth between SP and that number.
But there is no setting for r0, r1, r2 and so on. How do I get to these settings?
Solution: Hold [set] for 8 seconds when the [probe temperature] is showing.
See message #15 for programming details.
The programming instructions are not very clear.
All that I get when I press [set] is a number that goes from -50 to 150 degrees.
When I press [set] again it just goes back and forth between SP and that number.
But there is no setting for r0, r1, r2 and so on. How do I get to these settings?
Solution: Hold [set] for 8 seconds when the [probe temperature] is showing.
See message #15 for programming details.