Hey everybody! This is driving me absolutly bat sh** crazy! I want to power my grain mill with a dc motor because i want speed control and reverse ability. I have 2 dc motors to choose from. 1 is a 1HP 24v dc and the other is a 3 HP 110V DC treadmill motor. for the treadmill motor, i pulled the PWM board with it but cannot for the life of me figure out how to use it with the POT switch i bought. just cant get it to turn...
I know there is a way to get either one of these motor to spin on the cheap as my gaget buget is blown. i saw this video on you tube but i am a little leary on saftey as well as if i can even get a dc motor to slow down to 150RPMS.
any info i could get would be greatly appriciated!!
I know there is a way to get either one of these motor to spin on the cheap as my gaget buget is blown. i saw this video on you tube but i am a little leary on saftey as well as if i can even get a dc motor to slow down to 150RPMS.
any info i could get would be greatly appriciated!!
Last edited by a moderator: