Hi all, I was just given a temperature controller and thought I would use it, if possible, on a fermentation chamber I just built. The controller is this: http://www.parts-express.com/pe/showdetl.cfm?partnumber=320-518
What I can't figure out is how to attach the fan that I plan on using, which is a standard computer fan.
Below is what it looks like on the back of the controller. The three small pins on the right are for the temp probe. The larger port on the left has two slots on the right for power. The other two (out1 and out2) are for relays.
I hooked up the power and it works fine. But, I have no clue how to hook this up to a fan or what part(s) is needed to connect the fan to the out1 and/or out2. The manual is of little help to me. I'm not sure I have even given you enough information, but still hoping someone can point me in the right direction on how to wire it; what parts I need to get; etc.
As always, thanks in advance.
What I can't figure out is how to attach the fan that I plan on using, which is a standard computer fan.
Below is what it looks like on the back of the controller. The three small pins on the right are for the temp probe. The larger port on the left has two slots on the right for power. The other two (out1 and out2) are for relays.
I hooked up the power and it works fine. But, I have no clue how to hook this up to a fan or what part(s) is needed to connect the fan to the out1 and/or out2. The manual is of little help to me. I'm not sure I have even given you enough information, but still hoping someone can point me in the right direction on how to wire it; what parts I need to get; etc.
As always, thanks in advance.
