Hey All,
Looking for some suggestions on flow meters for my setup. I don’t have any knowledge in circuit board or arduino devices. I don’t really want to get into it either unless someone can dummy it way down. I don’t know if such a thing exists for what I’m wanting.
I’d like to get some flow meters to plumb in-line with my mash tun and HLT. I’d like to be able to set a consistent and repeatable recirculating flow rate in my mash tun. I’d also like to be able to set an even flow rate during fly sparging. One from the mash to the boil, and one from the HLT to the mash. Hopefully something that will tell me rate in gallons per minute.
Obviously meters would need to be able to handle temps up to 170 degrees.
Any questions, comments or suggestions welcome.
Looking for some suggestions on flow meters for my setup. I don’t have any knowledge in circuit board or arduino devices. I don’t really want to get into it either unless someone can dummy it way down. I don’t know if such a thing exists for what I’m wanting.
I’d like to get some flow meters to plumb in-line with my mash tun and HLT. I’d like to be able to set a consistent and repeatable recirculating flow rate in my mash tun. I’d also like to be able to set an even flow rate during fly sparging. One from the mash to the boil, and one from the HLT to the mash. Hopefully something that will tell me rate in gallons per minute.
Obviously meters would need to be able to handle temps up to 170 degrees.
Any questions, comments or suggestions welcome.