Flame Control

[identityales]

Building (like everyone it seems) a single tier setup and have a question. I'm trying to figure out how to plumb the gas line. I would like to run the high pressure burners off of a single propane tank with an adjustable regulator.

How are you all with similar setups adjusting your flame intensity for individual burners running at the same time?

It seems to me you need to have needle valves on each gas line, but I haven't seen that in the systems I've looked at on the board.

Cheers,
Kyle Larsen

 

[Wayne1]

Kyle,

I used two needle valves, one to each burner. The burners are piped with 3/8" tubing. It reduces to 1/4" to fit the needle valves. I run hose direct from the needle valves to the burners.

Here is a thread where I show off my build https://www.homebrewtalk.com/f51/brewstand-build-finished-1st-brew-today-117290/