Ok so, I brewed a MW Honey bee ale Extract kit, All went well no problems at all ... Brewed on 4/7 went to second fermenter on 4/12 SG was 1.046 which was fine and when racked to second was 1.006 which is well under the kits instruction sheet that called for a low of 1.010 so thought I would wait a few days and let it bubble itself out, Sooo 3 days later i just checked it and am getting a reading of 1.000? Can this be? I have about 6 of these extract kits under my belt and no problems at all but this has me a bit stumped .. I have seen some variations but nothing like this ... Oh , and other than flat it doesn't taste to bad Sooo what do you all think. I've just never seen this large a variant. Thanks