Hi.
Does anyone have experience?
I need some help my PID has RS485 built in, its 2 wire +ve and -ve.
I'm connecting PID to an RJ45, then a network cable to comport/USB adapter and on to a notebook with Win7 and PID manufactures software.
But software cannot detect the PID!!!
As far as I can tell from the information I've found the RS485 +ve goes to 4 and the -ve to 5 in the RJ45, is this correct?
The Pid settings are Baud 9600, parity even, DL 7, SB 1, Modus RTU. I have reflected those settings in the software and in the setup of the comport (Com3).
I'm stuck, I can't think of anything else to try unless I'm connecting the + and - to the wrong terminals.
Any help much appreciated.
Aamcle
Does anyone have experience?
I need some help my PID has RS485 built in, its 2 wire +ve and -ve.
I'm connecting PID to an RJ45, then a network cable to comport/USB adapter and on to a notebook with Win7 and PID manufactures software.
But software cannot detect the PID!!!
As far as I can tell from the information I've found the RS485 +ve goes to 4 and the -ve to 5 in the RJ45, is this correct?
The Pid settings are Baud 9600, parity even, DL 7, SB 1, Modus RTU. I have reflected those settings in the software and in the setup of the comport (Com3).
I'm stuck, I can't think of anything else to try unless I'm connecting the + and - to the wrong terminals.
Any help much appreciated.
Aamcle