Edgestar IB250

[Telemachus]

I'm hoping to drill a hole in the back of this, not for a shank, but for feed and output lines from a cold plate for my under counter soda setup.

Other than the alcohol and cornstarch method, I'm thinking I will just probe around in the foam in the back and make sure there are no metal coils.

Any advice is appreciated...

 

[3PDP]

did you have any luck with this project? I was looking to do the same thing with a edgestar for a cold plate but was a little worried because they claim this unit acts as a freezer therefor not needing a drain. and I didn't want liquid to freeze in the cold plate.

-Dan