Edgestar IB250

Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk:

Telemachus

Member
Joined
Apr 26, 2020
Messages
5
Reaction score
0
I'm hoping to drill a hole in the back of this, not for a shank, but for feed and output lines from a cold plate for my under counter soda setup.

Other than the alcohol and cornstarch method, I'm thinking I will just probe around in the foam in the back and make sure there are no metal coils.

Any advice is appreciated...
 

Attachments

3PDP

New Member
Joined
Mar 21, 2021
Messages
2
Reaction score
0
did you have any luck with this project? I was looking to do the same thing with a edgestar for a cold plate but was a little worried because they claim this unit acts as a freezer therefor not needing a drain. and I didn't want liquid to freeze in the cold plate.

-Dan
 
Top