Does this crush look ok?

[Stocktonbrew]

Hi guys, Just ran through ten pounds of pale malt with my new mill set at .039. There is a little more flour than I am used to, so I was wondering what you all think? As a side note, I used the Dewalt 10.5 amp drill and it worked like a champ.

 

[tagz]

Looks pretty good to me. Your husks are fairly intact as well. The true test will be your efficiency, but looks solid. You could probably even go finer if you don't get the numbers you like.

 

[stpug]

I like it!! The husks are really intact - that's great!! I'd go with it and figure out what it gives you - adjust from there on future batches.

 

[Stocktonbrew]

Thanks guys. I picked up the MM2 2.0. So far I love it. It was super easy to adjust and plowed through the grain. If this looks good to you guys I'm going to roll with it. Thanks!