kyle6286
Well-Known Member
I finally got all of my kegging stuff ready to go. Last night I went by my LHBS and got the last of what I needed - beer and gas disconnects and some extra lines. When I got home, I tried putting on the disconnects and for some reason, they would not go on. I know the gray one is the gas and that goes on the "In" and the beer goes on the "Out". I had to put a lot of muscle into just getting them to snap on, but they didn't fit snug at all. They were still very loose. Any reason why this is happening? Is it usually this difficult to connect these things, or do they usually just snap on?