tlarham
Well-Known Member
So I'm cleaning up my brewroom, and getting ready to scrap 3 kegs that are riddled with holes from a shotgun ( I got them that way from the scrapper). I salvaged the posts and gas tubes, 1 dip tube, and cut a 10 inch segment of another dip tube (thermowell?).
What else should I do to these bad boys before they hit the trash? Should I try and get the rubber feet off?
One of the kegs only has one little hole in it (ricochet) about 2/3 the way up the keg (smaller than a dime). How could I patch that small a hole...perhaps not for pressure/serving...but storing sanitizer maybe? Not a welder myself.
What do you all think?
What else should I do to these bad boys before they hit the trash? Should I try and get the rubber feet off?
One of the kegs only has one little hole in it (ricochet) about 2/3 the way up the keg (smaller than a dime). How could I patch that small a hole...perhaps not for pressure/serving...but storing sanitizer maybe? Not a welder myself.
What do you all think?