4TBBUCS
Well-Known Member
Blichmann G1 10Ga x3
SS BT Chronical BME 7Ga
Pressurized transfer kit
SS BT FTSS Temp Control
Stasis Glycol Chiller
Auber Brew Buddy Panel (240v / 30A)
Custom wall mount for panel
Blichmann Riptide pump x2
Blichmann Therminator
Hop strainer
Tilt Hydrometer
SS brew table / mash paddle
Pot coasters
All Temp probes, cables, etc
All SS QD and SS TC’s
Corny Kegs x2
Dual Jockey Box (50ft / SS)
Kegerator
#5 and #10 CO2 tanks
Dual manifold / single
Ink-bird Temp controller
New silicone brew line to plumb as desired.
Guarantee I’m leaving some things out!
Too much to write to be honest. If you can think it, I either have it or have misplaced it (regardless, it’s included). You’ll need either a truck or a trailer for sure. Most of the items have never been used and are new OR have very little use on them. I built two identical systems, one ended up as a pilot / experimental system for a LB. The other has been sitting unused in my garage for sometime now. System was built with quality components, nothing cheap, and zero corners cut! If you know what you’re looking at, then you know. Message me with any questions you may have. I will try my best to take pictures of all items listed. Bear with me, as my time is limited. Thanks.
$3800
SS BT Chronical BME 7Ga
Pressurized transfer kit
SS BT FTSS Temp Control
Stasis Glycol Chiller
Auber Brew Buddy Panel (240v / 30A)
Custom wall mount for panel
Blichmann Riptide pump x2
Blichmann Therminator
Hop strainer
Tilt Hydrometer
SS brew table / mash paddle
Pot coasters
All Temp probes, cables, etc
All SS QD and SS TC’s
Corny Kegs x2
Dual Jockey Box (50ft / SS)
Kegerator
#5 and #10 CO2 tanks
Dual manifold / single
Ink-bird Temp controller
New silicone brew line to plumb as desired.
Guarantee I’m leaving some things out!
Too much to write to be honest. If you can think it, I either have it or have misplaced it (regardless, it’s included). You’ll need either a truck or a trailer for sure. Most of the items have never been used and are new OR have very little use on them. I built two identical systems, one ended up as a pilot / experimental system for a LB. The other has been sitting unused in my garage for sometime now. System was built with quality components, nothing cheap, and zero corners cut! If you know what you’re looking at, then you know. Message me with any questions you may have. I will try my best to take pictures of all items listed. Bear with me, as my time is limited. Thanks.
$3800
