SeanGC
Well-Known Member
I'm looking to mount a male, shut off valve QD to my kegerator collar for my co2 tank. Only issue is, I can't seem to find good solution to effectively mount the male QD without jerry-rigging a solution.
I was hoping I could purchase this male QD: PLC VALVED PANEL MOUNT HOSE BARB COUPLING INSERT - 1/4 ID BARB
However, I want to mount the QD to the back of my collar, which is roughly 1.5" thick. This QD is made to fit a panel with a much thinner gauge.
Has anyone run into a similar issue? Is there another solution that would work in place of what I'm trying to put together? I really don't want to simply silicone/foam insulate the QD on, as I want it to be relatively sturdy and secure.
Thanks guys!
I was hoping I could purchase this male QD: PLC VALVED PANEL MOUNT HOSE BARB COUPLING INSERT - 1/4 ID BARB
However, I want to mount the QD to the back of my collar, which is roughly 1.5" thick. This QD is made to fit a panel with a much thinner gauge.
Has anyone run into a similar issue? Is there another solution that would work in place of what I'm trying to put together? I really don't want to simply silicone/foam insulate the QD on, as I want it to be relatively sturdy and secure.
Thanks guys!