JONNYROTTEN
Well-Known Member
I use an 18v dewalt cordless.I keep the trigger about 1/2 throttle.works great
I use an 18v dewalt cordless.I keep the trigger about 1/2 throttle.works great
Ran into this three roller at The Beer Essentials in Lakewood Washington today. It's a three roller mill but isnt a Monster Mill. The hardware and markings on it look an awful lot like a Cereal Killer. Has anyone seen these before?
this ones also branded as the kegco...
I'm still having no problems with my cereal killer mill... I have my gap set with a credit card and average 86% efficiency.. (I actually got 92% on my last brew for some reason.)
I plan to start at 0.035" and adjust from there, trying to get the highest eff without risking stuck or slow sparges. Do you all find that conditioning the malt helps when using a CK? It made a huge difference for me on the corona mill, but that's because it shredded the hulls otherwise.
If you're going to condition, I'd set the gap to around 22mil (0.022" or 0.55mm). That gives me the best crush for normal barley. For wheat malt, I close it to around 12mil or 0.3mm.
Enter your email address to join: