Cal Clone -- By the worlds least handy man

[tulsadad]

I would like to see you brewery. I'm from Tulsa and I'll going to start a Kal clone in the next few weeks. I just started brewing and haven't seen a Kal brewery run.

 

[augiedoggy]

Yes! This was 400 and i still need to buy the o-rings. Was not expecting this expense. Should have read the cost breakdown report a little closer!

what supplier are you using?
bargainfittings.com was the cheapest and best quality out of the few sources I tried. I still ended up with like 6 orders as I kept adding or forgetting things myself...

 

[IndyMcLovin]

subscribed

 

[mikescooling]

Awesome! I'm building a Kal clone also... Cutting those square holes SUCKED!

I have the same panel as the OP, it sucked cutting those holes. I used a dremel, roto-zip, bull snips, and anything else I could find. That panel is built like a tank. Looks good OP, you lost your amateur status. You are now handy.

 

[tulsadad]

Me too I should get my kit this week. I would like to see anyone use there brewery in Tulsa.