Burner Mounting Question

[Espi]

I ordered these burners from Northern Brewer...

I have a welder and am starting on my stand after the rest of the parts are collected.

I want to get some heat shield/ mounting rings bent up for this project. My fab guy has some free time now to do these before they will arrive.

I remember reading a 10 inch diameter will work, can someone verify?

Thanks for your help.

 

[DarkNoonBrewer]

I just measured the ID of the the blichmann burner surround. 11.0" I believe its the same casting...

 

[Espi]

OK thanks.. it may be best to hold off then and give the guy rolling the steel the actual burner.

 

[craigowens]

Yeah...be careful...I meant to measure today but I am pretty sure the diameter on the mounting points for these burners are closer to 12.25". I'll check tomorrow.