BrewBuilt X3 conical spunding kit sanitizer reservoir o-ring

[jwill911]

Related to the subject, anyone had to replace theirs? Got up this morning and the reservoir was empty, One inspection the o-ring was broken. I’m googling for “food grade silicone o-ring OD 72mm x ID 64mm x 4mm CS. I found some close and a bunch Nitrile rubber, also close size.
So with all that said for those that have been there done that, where did you get yours.
Also on a related subject I want to purchase extra 4” and 8” Tri-Clamp gaskets just in case.
Thanks, jw

 

[jwill911]

Hi, Me again. Also related to the BrewBuilt spunding kit and liquid filled gauge, I have mine mounted with a “T” 1.5” and the gauge is horizontal, maybe I’m OCD but I want it vertical. I’m looking for a SS sanitary 1.5” cri clamp like this picture but not willing to pay $229

 

[kurds_2408]

I have an X3 but don’t have the spunding valve so no help there. For your other post why not just put the gauge on its own port? The X3 has ports to spare.

 

[sibelman]

You might need to use a tee and and elbow.

 

[jwill911]

Yea. I was planning after this batch is out of the fermenter to dispense with the "T" and put the gauge on one of the 1.5" TC on the top. Thanks for the replies. I reached out to Bobby at Brewhardware for the o-ring for the liquid reservoir and a couple spare 4" and 8" TC gaskets. I bought the X3 from him.