ingchr1
Well-Known Member
With the template and a step bit the install of the coil was relatively straightforward. Just as a caution, with the three prongs there's not a whole lot of room for error.how was the installation process ?
How long did it take ?
Will your drain dip tube fit between the coils ?
( I had 'heard' the coil needed to be near the front of a BM kettle so the dip tube could fit between the coils )
Pretty straight forward ? ( any idiot like me could do ? )
Looks great !!!
For a pickup tube I have a 90 degree elbow right off the vessel wall, so it doesn't even reach the coil and the coil is slightly above it. You may be able to see it in the photo I posted. This is the pickup I had on my old kettle.
Also, thank you for the compliment.