mmonacel
Well-Known Member
Thanks for reading this!
I'm all set up and about to bottle and realized that in my bottling bucket spout there's some gunk in there (likely mold) that I can't get out. Not sure if all spouts are like this, but mine is apparently comprised of two major clear pieces plus the red actual spout itself. The two clear pieces rotate which allows you to spin the red spout around if needed. Well, the gunk is in between the where the two pieces meet and since it doesn't disassemble I can't get to it. The gunk isn't in the main flow path, but obviously I'm not looking to take risks.
I'm boiling the entire assembly right now and then will dunk and soak in Star San. Think I'm good or should I ditch it, order a new part, and try again later?
I'm all set up and about to bottle and realized that in my bottling bucket spout there's some gunk in there (likely mold) that I can't get out. Not sure if all spouts are like this, but mine is apparently comprised of two major clear pieces plus the red actual spout itself. The two clear pieces rotate which allows you to spin the red spout around if needed. Well, the gunk is in between the where the two pieces meet and since it doesn't disassemble I can't get to it. The gunk isn't in the main flow path, but obviously I'm not looking to take risks.
I'm boiling the entire assembly right now and then will dunk and soak in Star San. Think I'm good or should I ditch it, order a new part, and try again later?