Wow, thanks for all the replies and offers for help.
So whomever wants to help, I guess someone take the lead. So maybe whoever posts back first? Is that cool?
I didn't realize that the file changed from what I thought it was. Basically stuff was added that I don't need. Can it be changed to look like the version I posted below by removing a bunch of the detail such as all the light blue, green, red, purple stuff, and the extension bar for the controls on the left? I just need the bare bones stand and its dimensions From there I would like the following done:
1) Remove the 3 circles from the top piece along with the little squares inside the circles.
2) Make the top-down dimensions of the stand slightly smaller. In other words I want the distance between bars for the burners to be 12.5" instead of 13.5". I want to keep the length at 62" so push the distance between each burner to 7.25" from the existing 6.25". I think those dimensions are right???
This would also effect the bottom piece's width between tubing as 12.5" from the existing 13.5".
3) I would like to add angle brackets to each square for the burners. The brackets should look like the pic below. So 12 pieces total. I am not sure of the dimensions of the brackets, but I would like them about the same as the picture below. Also could you add a dimensional line showing the diagonal distance between the angle brackets?
4) Can you make the height of the stand 22" instead of 20" and then make the height of the wheels 4" instead of 5"
That's it. Thank you so much.