Ever since i took the lid gasket out to clean, it has had trouble sealing. It’s like the gasket is too big in circumference to properly fit... can’t get it to lie flat in the lid’s groove- it’s wavy and redundant. I tried lubing it up to help it seal without luck.
I just started a beer. It’s fermenting. I have a tilt hydrometer and it’s dropped from 1.083 to 1.075 and when i opened it up to lube up the gasket it’s foamy. Yet no bubbles from the airlock. Not sure where else it could be leaking from. Bung in the lid is well seated.
Anyone else have trouble with this.
I just started a beer. It’s fermenting. I have a tilt hydrometer and it’s dropped from 1.083 to 1.075 and when i opened it up to lube up the gasket it’s foamy. Yet no bubbles from the airlock. Not sure where else it could be leaking from. Bung in the lid is well seated.
Anyone else have trouble with this.