I built this kegerator when I was homebrewing every other weekend, but since I haven't brewed a batch in over 2 years, it's time for it to go. It works 100% and keeps beer at any temperature you want with a digital temperature controller displaying the temperature right between the taps. All taps are Perlick stainless steel taps. Inside, there is a dual regulator with two sets of CO2 banks (1 with 4 outlets, and one with two) so you can maintain two separate pressures on your kegs. I currently have the taps set up with 3 ball lock homebrew connectors and 3 commercial Sanke connectors for commercial kegs. Currently, the CO2 stays inside the kegerator, so capacity is only 5 kegs, but it can easily be relocated outside the kegerator to fit a full 6 ball lock kegs. Commerical sixtels will only fit 3 at a time inside, with 1-2 ball lock kegs depending where the CO2 tank is. Drip trays are also stainless steel, so again no worries about rusting. It's a little banged up inside from putting kegs in and out but doesn't affect performance.
Total Cost of the Kegerator in parts was ~$1000. I can deliver reasonable local to 08742 if necessary. Looking to get $600 for it.