Weissbier
Well-Known Member
Just got one on sale at Target for $13.95! I couldn't resist...time to go ALL GRAIN!
I have one. It makes a great MLT.
Was there insulation in the walls where you drilled?
...
Now I think I'll have temps problems.
So, one poster on this thread says he loses 2 degrees over an hour. Another says it's just fine. Another says it is good enough.
Are there any other opinions out there? I'm getting ready to brew in subfreezing temps, so it would be good to know ASAP before I cut into this cooler and can't return it anymore.
Thanks,
I just saw these today for about the $13.95 price, I'm gonna get one tomorrow.
I plan on filling the lid with spray foam. (one I looked at had flip open compartment on top but I'll fill that with foam too!)
What about the sides? How's the insulation there?
Maybe fill sides with spray foam?
I just saw these today for about the $13.95 price, I'm gonna get one tomorrow.
I plan on filling the lid with spray foam. (one I looked at had flip open compartment on top but I'll fill that with foam too!)
What about the sides? How's the insulation there?
Maybe fill sides with spray foam?
Yeah, I actually put my bulkhead level with the bottom of the cooler, rather than down in the indentation so I didn't have to use an extra piece of CPVC for the angle. I don't think it will mean I lose a lot of liquid in the long run.
Actually, from the outside, you can see a flattened area on the side of the right side of the cooler (if looking from the front), and that is where the spigot would normally go.
Enter your email address to join: