Motor is a 65670 kit with fan blades $15 at the local hvac shop. Too much rpm?
Started with a scrap computers power supply and fan. Plan was to mod the supply to run the fan above it in a old compressor e box housing. Little sheet metal work and wire it up and run it.
Used the soldering iron to remove what I didn't need and nothing worked. Tossed it in the trash.
Went with a motor at the refrigeration shop. Two holes in the bottom to bolt up, wire it in and cut up the fan blade to fit the magnets close the the bottom. The motor and shaft to fit with 1/4". Thinking 3000rpm is a bit much but we will see.
I need to attach some rubber feet.
Started with a scrap computers power supply and fan. Plan was to mod the supply to run the fan above it in a old compressor e box housing. Little sheet metal work and wire it up and run it.
Used the soldering iron to remove what I didn't need and nothing worked. Tossed it in the trash.
Went with a motor at the refrigeration shop. Two holes in the bottom to bolt up, wire it in and cut up the fan blade to fit the magnets close the the bottom. The motor and shaft to fit with 1/4". Thinking 3000rpm is a bit much but we will see.
I need to attach some rubber feet.