drewmedic23
Well-Known Member
After a long hiatus from brewing, I've jumped back into it and want to change some things around. I want to sell my control panel so I can build a new one. I built this one myself and it always worked great for me; just used it yesterday and it worked great. I'm not quite sure what to sell it for but after looking around at other classified posts, I'd like to get $750
for it; should be enough to cover my next project.
The box works perfectly and is in great condition. I couldn't find the key yesterday so I just bypassed the key switch on the box for the day.
It has an auber 2352 PID on the left, auber JSL-73B timer in the middle, and auber DSPR1 on the right.
The switch on top of the timer switches SSR control from the PID to the boil controller.
Both red buttons under the pid and timer are for the alarm which is between the two red buttons and the red momentary button under the timer alarm button is for the timer start/reset.
The yellow button on the bottom closes the contactor for the element and the white led shows when its firing.
The two blue buttons are for 120v outlets.
Green is power and red is e-stop (the e-stop shuts off the main contactor, it does not ground-fault the circuit).
I will include the metal braided connector for the temp probe, you just need a pt100 to go with it.
Everything was purchased from Auber Instruments. I know the wiring isn't beautiful but it functions flawlessly. The PID is showing an error because the probe isn't attached. Buyer covers actual s&h.
for it; should be enough to cover my next project.
The box works perfectly and is in great condition. I couldn't find the key yesterday so I just bypassed the key switch on the box for the day.
It has an auber 2352 PID on the left, auber JSL-73B timer in the middle, and auber DSPR1 on the right.
The switch on top of the timer switches SSR control from the PID to the boil controller.
Both red buttons under the pid and timer are for the alarm which is between the two red buttons and the red momentary button under the timer alarm button is for the timer start/reset.
The yellow button on the bottom closes the contactor for the element and the white led shows when its firing.
The two blue buttons are for 120v outlets.
Green is power and red is e-stop (the e-stop shuts off the main contactor, it does not ground-fault the circuit).
I will include the metal braided connector for the temp probe, you just need a pt100 to go with it.
Everything was purchased from Auber Instruments. I know the wiring isn't beautiful but it functions flawlessly. The PID is showing an error because the probe isn't attached. Buyer covers actual s&h.
