Ok so I recently got a new Kegoco 2 tap kegerator. I've got one used 5 gallon keg from them and a brand new 3 gallon from northern brewer. Set everything up, kegged beer, set pressure to 15psi. Next morning, CO2 is empty. Weird part is, neither keg has any pressure once I open pressure relief valve. I thought the issue was a faulty pressure relief valve on the used keg. Got it replaced and CO2 refilled. Set pressure again. Everything seemed to seal nicely. Didn't hear any gas escaping. Next morning checked, CO2 level dropped slightly but kegs were still pressurized. One day later, this evening, CO2 empty and no pressure in either keg.
Now obviously I have a leak. All my O rings look good. I tightened all the posts with a wrench(not as tight as they could have been). I'm just perplexed because neither keg had any pressure...wasn't expecting that if there was a leak in one keg. I'm getting the CO2 filled tomorrow morning and will be putting starsan on all possible areas to find the leak.
In the mean time, any hints on where my link could be? Any tips that people have from experience? Thanks a lot guys! I just want my kegged beer already!
Now obviously I have a leak. All my O rings look good. I tightened all the posts with a wrench(not as tight as they could have been). I'm just perplexed because neither keg had any pressure...wasn't expecting that if there was a leak in one keg. I'm getting the CO2 filled tomorrow morning and will be putting starsan on all possible areas to find the leak.
In the mean time, any hints on where my link could be? Any tips that people have from experience? Thanks a lot guys! I just want my kegged beer already!