OP
OP
GoCobbers95
Member
Welp...
I made my first attempt at silver soldering on my current brew kettles. It went okay. Not near as intimidating as I was thinking it would be. What I learned is that I need a better stand to keep the kettle level and therefore keep the solder from running. Had some slight pooling outside of the dimple that I believe I will avoid with a bit of preparation. They cleaned up well and water tested without issue. Going to mess around with it all a bit more before I buy some kettles and start the project officially.
Thanks all!
I made my first attempt at silver soldering on my current brew kettles. It went okay. Not near as intimidating as I was thinking it would be. What I learned is that I need a better stand to keep the kettle level and therefore keep the solder from running. Had some slight pooling outside of the dimple that I believe I will avoid with a bit of preparation. They cleaned up well and water tested without issue. Going to mess around with it all a bit more before I buy some kettles and start the project officially.
Thanks all!
