Recent content by TnFarmer

I got the funds and sent out the taps. I am not sure how to close a thread.

I think these are spoken for. Will post again if it falls through. Pm sent.

How about two each? Spread the wealth.

I have four free economy taps and shanks. A friend gave them to me and they served me well, but I have upgraded to perlicks. So I thought I would pass them on. If you pay shipping, you can have them. I think they will fit in a small flat rate box, if not, a medium ($6 or 11). Pm me if interested...

Thanks Golddigge. I was thinking that the plate apparatus was too big of a hassle. But I didnt know if someone else could see something good in it. Any ideas other than a mash screen for the rest of it? Also is there no way to use a 12.5" in a keggle? I would rather not buy a screen since I have...

Just scored 6 or seven of these stainless trays with perforated ss plates on top. The perforated disk is 12.5" in diameter and has a 1 5/8" hole in the middle. It has 4 tabs welded on the bottom that hook into the plate (could add rigidity under a grain load?). The plate is 13 5/8" diam. and has...

$300 shipped....

I have an analog Johnson controller that I thought was a 3 degree differential but I will have to check. With that controller if I put the probe near the carboy but not attached and I set it at the low end of the yeast recommended temperature do you think I will have too large of a temp swing. I...

I have a temperature controller for an extra fridge that we have. I mainly make ales and I have a couple of questions. 1. Should I secure the temp probe to the side of my primary carboy? 2. Should I set the temp controller to the low end or even slightly below the low end of the recommended...

Thanks. I do not have the tool to remove. I am hopefully going to mess with it today to see if I can do it. I will let you know how it goes.

I am wondering if there is anything special I need to do or if I will cause problems by transferring a carbonated beer from a corny keg to a Sanke keg. I want to do so in order to travel with the Sanke without CO2 and then use a hand pump to dispense at a party. I was planning on just using a...

Thanks. Money sent.

I will take them if still available.

Did the previous poster take it? If not, I will.

Please add me too. Thanks.