So I have a tilt and currently use with my smartphone. Only thing I dont like is that I only get readings when I'm nearby. So I dont have any data or charts while I'm at work.
Want to setup the Tilt Pi but here are my questions/concerns
1) never used raspberry pi but can follow instructions...
The Ftss controller flashed all 8's, 88.8.8 then flashes and displays the current temp. It continues to do this and never turns on the pump. Not sure if the video was able to attach.
1.010 with hydrometer. Took a reading with refractometer as well and it came up with same result as the 1st time.
Tastes fine. Odd thing is it almost feels slightly carbonated.
1) Using refractometer and drew 3 samples because I thought I could have had a bad reading as well bit came up.with same result each time. And I did check calibration as well
2) forgive my ignorance but what is glucoamylase?
3) maybe contamination, pretty good with my sanitation procedures but...
1) Brewed an Irish Red Ale on 1/24.
2) Nottingham Ale Yeast in at 62 degrees and within 2 hours temp stabilized at 68 degrees. Use FTSs and temp has remained between 66 and 70 degrees the whole time.
3) have not seen or heard an activity for 5 days now. Using blow off tube with no visible...
Thanks Red army, any tips and tricks for using the mash and boil? I'll need to install some outlets where I plan on brewing so probably won't be able to for a couple weeks