Don't worry you're not the only one who can't afford a can seamer. They're freaking expensive! Nice capper!Finally upgrading my capper(after finally admitting i cant afford a can seamer)View attachment 609373
Don't worry you're not the only one who can't afford a can seamer. They're freaking expensive! Nice capper!Finally upgrading my capper(after finally admitting i cant afford a can seamer)View attachment 609373
View attachment 609191
Since @TBC showed his, I’ll show mine! [emoji6][emoji6]
I would say I hope you enjoy them but I already know the answer! Haha Especially since I know I’ll enjoy mine!
Thanks again for meeting up to trade beers, grab a bite to eat (sucks eating alone all week) and of course talking beer!
@imasickboy I’ll try to figure out a way to swing by and do the same with you one of these trips.
Time for bed!
One more reason to buy a grain mill!!!My grain order from Austin brewing supplies came in, I chuckled as the hops are labeled from adventures in homebrewing! Also to note the grains look poorly milled
Link? I'm only seeing 34.99, if it's 10 off i'l pick up an extra.Hasn't arrived yet, but... Ordered another inkbird 308. Amazon deal for 24.99!
Link? I'm only seeing 34.99, if it's 10 off i'l pick up an extra.
Just picked one up, Thanks!Go to the "deals" forum. I posted a code over there
Just picked one up, Thanks!
Me too!Just picked one up, Thanks!
There's some of my blood sweat and tears in that Ryzen ;-)A new 'puter!
View attachment 610002
Nice piece of kit! Where did you order that from? I'd like one myself if it's not too expensive
Nice piece of kit! Where did you order that from? I'd like one myself if it's not too expensive
I know you will love it! I did my third brew on it today. So easy to brew and clean up after.
I’m excited to give it a try. Unfortunately, I have to wait until Wednesday! Just need to figure out what to brew.I know you will love it! I did my third brew on it today. So easy to brew and clean up after.
Assuming you already had a single regulator before, you can now run 3 different pressures...The ability to run 2 different co2 pressures off 1 can came in the mail. Currently have a brut at 20 psi and the rest at 14.View attachment 611131
Most definitely will. I had the same issues when I first used my unitank without the racking arm. Cheersracking arm for my conical. i've done several batches without one and just filling kegs from the racking port but i keep getting too much 'stuff' in the kegs. there must be stuff settling in the port as well as running down the wall, hopefully the arm will help.
racking arm for my conical. i've done several batches without one and just filling kegs from the racking port but i keep getting too much 'stuff' in the kegs. there must be stuff settling in the port as well as running down the wall, hopefully the arm will help.
I got one for Christmas and just used it on my first brew, working like a charm! Can't wait for the cold crash
It’s been a year and a half since I last brewed. I’ve really been missing it so have purchased some equipment to solve some of the problems that I had when I was actively brewing.
1. I installed a 4x2 tub sink at a height comfortable for me @ 6’1”. There is also plenty of room to clean a 15 gallon pot and kegs.
2. Got a stainless counterflow chiller. I always hated putting my immersion chiller in the beer.
3. A large basket for hop additions. Keeps that poopy contained and out of my pump.
4. This for cold crashing.
Just need to hand my control panel up again since I put the new sink in front of where it used to be and I’ll be back at it.
Enter your email address to join: