Datchew
Well-Known Member
I do the 3-tier keggle all-grain gravity thing with the cornys and the fridge. Been there done that but I'm planning to make some hardware changes and despite this being mashed out heaps of times, I can't seem to find the topic.
Somewhere I read where folks assembled their internal pickup tubes made of copper bits but they did not solder them together. For disassembly and cleaning purposes I think.
Well, i'm about to get soldering and I was thinking about skipping it.
Anybody just stack them up and if so, any complaints?
Also, I'm putting a T-fitting in my MLT for a stainless braided loop. It's 0.5" copper T-fitting and I can't find any braided line that is true 3/4 ,or 5/8 or whatever it is. None of them will fit on the t-fitting. Where do I get the large braided stainless?
THanks.
Somewhere I read where folks assembled their internal pickup tubes made of copper bits but they did not solder them together. For disassembly and cleaning purposes I think.
Well, i'm about to get soldering and I was thinking about skipping it.
Anybody just stack them up and if so, any complaints?
Also, I'm putting a T-fitting in my MLT for a stainless braided loop. It's 0.5" copper T-fitting and I can't find any braided line that is true 3/4 ,or 5/8 or whatever it is. None of them will fit on the t-fitting. Where do I get the large braided stainless?
THanks.