Hi Andrew, just curious is the hole required for the PG21 gland a lot bigger than the hole that is already drilled in the end cap. I have no way of knowing as Lowes and Home Depot did not have any left by me. So I will probably order two of them online. I wanted to know if my step bits will work and if they are big enough, or if I need to drill them out another way. Thanks for your time!
John
As I remember, the hole just needed to be opened a slight bit. My step bit did the job easily. I just clamped the piece down and it was done in no time.
I think that after I added this gland, there was very little space for the ring terminal on the ground lug. I had to shave off part of the ring terminal on my grinder to get it to seat properly, but it all worked out fine in the end.
It seems that others here have found suitable glands that didn't require this hole to be widened. You might investigate that before you buy these. I'm not positive though.